Forum Problems Installing LAMS: Re: problem with video recorder


 
Search: 

2: Re: problem with video recorder
In response to 1 09/04/11 08:57 PM
[ Reply | Forward ]
Hi Jong-Dae,

How are you? Great to hear from you again.

The video recorder is always tricky as it require some special ports open if you just install it out of the box.

I have written some instructions on how to get it to work over http so you won't require to open ports. It's a bit tricky as there's quite a few things to change, but it usually works at the end :-) The bit that you want to do is the "Using RTMPT".

Here's the link:

http://is.gd/6L6Rn7

Thanks,

Ernie

Posted by Ernie Ghiglione

3: Re: Re: problem with video recorder
In response to 2 09/05/11 05:19 AM
[ Reply | Forward ]
Hi, How are you?

I could run the demo of red5 server. The red5 server was installed with a lams server. The link for setting port for rtmpt was broken. I was unable to set up video recorder for lams.

Posted by Jong-D Park

4: Re: Re: Re: problem with video recorder
In response to 3 09/05/11 06:07 AM
[ Reply | Forward ]
I want to confirm that I should install red5 with url http://localhost:5080/ while I have to use specific ip when I configure lams media server setting. Is this correct?

Posted by Jong-D Park

5: Re: Re: Re: Re: problem with video recorder
In response to 4 09/05/11 06:33 AM
[ Reply | Forward ]
I found my mistake. I did input wrong addresses for the Media Server URL and for the Media Server Recordings URL. (exchanged). The instruction at http://wiki.lamsfoundation.org/display/lamsdocs/Installing+a+media+server+%28Red5%29+for+LAMS may be edited such that

--------------------------------------------------------
The Media Server URL is the URL for the Red5 server so this should be rtmp://172.x.x.x/ (of course replace the 172.x.x.x with the domain or the IP of the server in which you installed Red5.

As for the Media Server Recordings URL, this is the directory from where the LAMS server will "grab" the recordings and export them when required (think export portfolio, sequence export, etc). This should look like: http://172.x.x.x:5080/oflaDemo/streams/ (again replace the 172.x.x.x with the domain or the IP)
--------------------------------------------------------
be changed to
--------------------------------------------------------
The Media Server Recordings URL, this is the directory from where the LAMS server will "grab" the recordings and export them when required (think export portfolio, sequence export, etc). This should look like: http://172.x.x.x:5080/oflaDemo/streams/ (again replace the 172.x.x.x with the domain or the IP)

As fo the Media Server URL is the URL for the Red5 server so this should be rtmp://172.x.x.x/ (of course replace the 172.x.x.x with the domain or the IP of the server in which you installed Red5.
-----------------------------------------------
to match the order of input fields of lams settings.

Posted by Jong-D Park

Reply to first post on this page
Back to Problems Installing LAMS