Forum Problems Installing LAMS: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: problems with building LAMS from source


 
Search: 

17: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: problems with building LAMS from source
In response to 15 07/22/09 02:43 PM
[ Reply | Forward ]
I have compiled lams as per the hot-to, however, without correctly configuring the insert_lams_unix_config_data.sql i think.. i did not get any errors while executing the "ant" commands.. Does this mean the build was successful?

The last line in the how-to says "Go into your jboss-5 directory and start it". I ran the run.sh file in the jboss5.1.0GA directory. It looked to have started after a little more than 4 minutes... but now i dont know what next! how do i access lams?

Posted by Navin Jathan

18: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: Re: problems with building LAMS from source
In response to 17 07/22/09 03:33 PM
[ Reply | Forward ]
Hi Navin,

Make sure you start jboss using the run.sh script. In JBoss5, it seems that you need to bind the IP to it. So run it as ./run.sh -b {here-goes-your-IP}

Once JBoss starts, point your browser to http://{here-goes-your-IP}:8080/lams

And that should do.

ernie

Posted by Ernie Ghiglione

Reply to first post on this page
Back to Problems Installing LAMS
.LRN Home